Currencies:
EnglishNederlandseFinnishFranšaisDeutschHebrewItalianoLithuanianPolishPortuguesEspa˝olSwedish

Shopping Cart

now in your cart 0 items

Rifle
:
Languages:
English  Nederlandse  Finnish  Franšais  Deutsch  
Hebrew  Italiano  Lithuanian  Polish  Portugues  
Espa˝ol  Swedish  
:
Sponsors:


banner_lyman

banner_lee

banner_tapco

banner_2745894

banner_lead_bullets

Online Payments
Shooting

Accu-strut Stabilizer Mini 14/30, Stainless Steel XDrill ASXD-S


USD $146.94

Add to Cart:


Mini Fourteen/30 Stabilizer Stainless Steel New! XDrill Recent tests strongly support the contention that accuracy improvements are primarily the result of the strut's stabilizing geometry rather than the simple addition of dampening mass. This allows us to develop more lightweight but still effective strut designs. Barrel strut for Ruger 181-Present series rifles. Provides mechanical rigidity for thin carbine barrel, reducing accuracy-killing vibrations. The 6-inch 2-clamp configuration gives your best opportunity for performance increases. Typical improvement is 50-75% reduction in group size for earlier straight-barrel rifles, and up to 33% on the new tapered barrels. Your actual experience will vary. New super-lightweight version. Features cross-drilled lightening holes. Lightening holes for weight reduction. Hollow endplug for weight reduction and preventing contamination. Its about an ounce lighter than LT model yet the acccurization performance is about the same. Also significantly aids in barrel over-heating problems, reduces load sensitivity, and enhances the appearance of your Mini. Proprietary Flex-clamp design accommodates newer tapered barrels, an Accu-strut exclusive. Dimensions: Length: 5-7/8" Weight: 7.0 oz APPLICATION GUIDE: Regular (6") Models (A2, LT, HS) Older straight-profile 9/16" barrel New tapered 5/8" barrel Perfect for Ruger 181-present series rifles with full-length barrels. Not recommended for tapered 16ö short barrel versions with flash hider as clamps will be positioned too closely together. OK for models without the flash hider. Will not fit early 180-series, as rear of strut will interfere with sling installation point. Will not fit rifles with mid-barrel bayonet lugs (i.e. older GB models). Will not fit on "Target" models due to the much larger barrels. Harris bipod adaptor: strut sits forward a bit to accommodate "forks". May not be able to use the rear set-screws. ASI Tuneable Gas Block: The Accu-strut will not work with this product due to interference with the adjustment screw. Ultimak rail: Rear clamp must be shifted forward a bit to clear extended rail. Amega Ranges rail: installs with no modification.


  • Model: XDRILL-S
  • Shipping Weight: 0.95lbs
  • 7 Units in Stock
  • Manufactured by: Accu-Strut